BOLIY Pro3600Si/E Especificaciones descargar pdf (Pagina 12)

OPERATION

STARTING THE ENGINE

NOTE:

Before starting the engine, do not connect any electric devices.

1. Turn the fuel switch lever to the “ON” position.

2. Turn the engine switch to the “ON” position.

3. Hold the choke knob fully out for a cold start.

Note: Sometimes the choke is required to start a warm engine.

4. Pull slowly on the recoil starter until it is engaged, then pull it briskly. (Electric start model press engine

start button to start.)

5. After the engine starts, warm up the engine until the engine does not stop when the choke knob is returned

to the original position.

6. Push the choke knob back to the original position.

NOTE:

When starting the engine in areas where the ambient temperature is below 0°/32° F run the engine for one

to three minutes to warm up the engine.

ECONOMY CONTROL SWITCH

Engine speed is kept at idle automatically when the electrical device is disconnected and is returned to the

proper speed by the electrical load when the electrical device is reconnected. The economy control switch

in “ON” position is recommended to minimize the fuel consumption while in normal operation.

NOTE:

When high electrical load devices are connected simultaneously, turn the economy control switch to the

“OFF” position, the engine speed will increase to reduce voltage changes. Otherwise the generator will not

operate sufﬁ ciently to run high demand electrical devices.

CHOKE

OFF

ON OFF

1. 2.

3. 6.



      



    

DIGITAL

D I G I T A L

TECH

T E C H

PROTECTOR

(PUSH)

ON OFF

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

BOLIY Pro3600Si/E Especificaciones Pagina 12