BOLIY Pro3600Si/E Especificaciones descargar pdf (Pagina 17)

SPARK PLUG INSPECTION

You should periodically remove and inspect the spark plug.

1. Check for discoloration and remove the carbon.

2. Check the spark plug type and gap.

Standard electrode color: Tan Color

Standard Spark Plug: BPR4ES (NGK) (F7RTC)

Gap: (0.028 – 0.031 inches)

3. Install the spark plug.

Spark Plug Torque: 14 lbs. – Ft.

ENGINE OIL REPLACEMENT

1. Place the machine on a level surface and warm up the engine. Then stop the engine.

2. Remove the rubber cap on the bottom.

3. Place an oil pan under the engine. Remove the drain bolt.

4. Open the oil ﬁ ller cover as shown and remove the oil ﬁ ller cap so

that the oil can be completely drained.

5. Check the drain bolt, gasket, oil ﬁ ller gap and O-ring.

6. Reinstall the oil drain bolt. - Drain Bolt Torque: 12 Ft. lbs.

7. Add engine oil to the upper level.

• Recommended oil for most climates: 10W30

• For extremely cold conditions the oil viscosity may be lowered to ease starting: 5W30

• Engine Oil Quantity: 0.63 US qt

NOTE:

Recommended engine oil classiﬁ cation: API Service “SE” or “SF”

Be sure no foreign material enters the crankcase.

8. Install the oil ﬁ ller cap.

9. Install the rubber cap on the bottom.

Be sure to install securely to prevent from falling off during operation.

10. Close the oil ﬁ ller cover.

FUEL FILTER

Do not smoke or have an open ﬂ ame in the vicinity of the fuel and solvent.

1. Stop the engine.

2. Clamp the fuel line with the clip.

3. Replace the fuel ﬁ lter.

FUEL TANK FILTER

1. Remove the fuel tank cap and ﬁ lter.

2. Clean the ﬁ lter with solvent, if damaged, replace.

3. Wipe the ﬁ lter and insert it.

Be sure the tank cap is securely tightened.

WARNING

CAUTION

(0.028-0.031 inch)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

BOLIY Pro3600Si/E Especificaciones Pagina 17